詳情

To overcome this weakness, Lyra conducted a careful investigation of X-core coils, using a combination of mathematical analysis and hands-on experimentation. The outcome of the analysis program was a very specific X-core shape that not only had higher efficiency than any previous X-core cartridge, but also surpassed the efficiency of our earlier square-coil cartridge designs.

Rather than using all of the extra efficiency to single-mindedly increase the output voltage, we chose to allocate part of the extra efficiency to increase the output voltage (12% higher than Titan i), and use the remainder of the extra efficiency to reduce the amount of wire in the coils (22% less than Titan i). The lowered mass further improves tracking performance, while the higher output and lower internal impedance allow phono stages to perform better.

Etna uses Lyra's "New Angle" technology, which mechanically pre-biases the signal coils so that the vertical tracking force brings them into perfect alignment with the front and rear magnets when LP playback takes place. This system also equalizes out discrepancies in vertical and horizontal compliances, and enables Etna's coils to move with equal ease in all directions for wider dynamics, higher resolution, and improved tracking.

In every possible way, we have done our utmost to enable Etna to reach the very highest levels of performance. While Etna is second from the top in Lyra's line, one listen will demonstrate that its performance would define the very top of any other cartridge line.

Specifications for LYRA ETNA

Designer: Jonathan Carr
Builder: Yoshinori Mishima
Type: Medium weight, medium compliance, low-impedance moving coil cartridge
Stylus: Lyra-designed long-footprint variable-radius line-contact nude diamond (3um?70um profile, block dimensions 0.08 x 0.12 x 0.5mm), slot-mounted
Cantilever system: Diamond-coated solid boron rod with short one-point wire suspension, directly mounted into cartridge body via high-pressure knife-edge system
Coils: 2-layer deep, 6 N high-purity copper, chemically-purified high purity iron X-shaped former, 4.2 ohm self impedance, 11uH inductance
Output voltage: 0.56 mV@5 cm/sec., zero to peak, 45 degrees (CBS test record, other test records may alter results)
Frequency range: 10 Hz-50 kHz
Channel separation: 35 dB or better at 1 kHz
Compliance: Approx. 12 X10 cm/dyne at 100 Hz
Vertical tracking angle: 20 degrees
Cartridge body: Multi-material (titanium, duralumin, bronze, stainless steel) self-clamping construction with reduced-surface higher-pressure headshell contact area, predominately non-parallel shaping, phase-interference resonance-controlling mechanisms, body threaded for mounting screws
Cartridge mounting screws: 2.6 mm 0.45 pitch JIS standard Cartridge weight (without stylus cover): 9.2g
Distance from mounting holes to stylus tip: 9.52mm
Recommended tracking force: 1.68-1.78g (1.72 g recommended)
Recommended load directly into MC phono input: 104 ohm-887ohm (determine by listening, or follow detailed guidelines in owner's manual)
Recommended load via step-up transformer: 5-15 ohm (connect step-up transformer's output to 10kohm-47kohm MM-level RIAA input, preferably via short, low-capacitance cable)
Recommended tonearm: High-quality pivoted or linear (tangential) tonearm with rigid bearing(s), adjustable anti-skating force, preferably VTA adjustment